Siemens SINUMERIK 840D sl Series Diagnostics Manual page 253

08/2005
%2 = Block number, label
Definitions: The addresses programmed in the block are not compatible with the modal syntax-deter-
mining G function.
Example:
N100 G01 ... I .. J.. K.. LF
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Correct the displayed block and ensure that the G functions and addresses in the block
are in agreement.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
15500
Channel %1 block %2 illegal angle of shear
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The function CSHEAR has been called with an illegal (impossible) angle of shear, e.g.
when the sum of angles between the axis vectors is greater than 360 degrees.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Program the angle of shear in accordance with the geometrical conditions of the machine
and workpiece system.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15700
Channel %1 block %2 illegal cycle alarm number %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Cycle alarm number
Definitions: A SETAL command has been programmed with a cycle alarm number less than 60 000 or
greater than 67 999.
Alarm reactions of Siemens standard cycles:
Nos. 61,000 -61,999: Interpreter stop; delete with Reset
Nos. 62 000 - 62 999: Compensation block; delete with NC Start
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Program alarm number in the SETAL instruction in the correct range.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
15800
Channel %1 block %2 wrong starting conditions for CONTPRON/CONTDCON
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: There is an error in the start conditions for CONTPRON/CONDCON:
• G40 not active
• SPLINE or POLY active
Reactions: - Interpreter stop
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-253