Siemens SINUMERIK 840D sl Series Diagnostics Manual page 145

08/2005
- Interface signals are set.
- Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Check the block structure and correct in accordance with the programming requirements.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12120
Channel %1 block %2 G function not separately programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The G function programmed in this block must be alone in the block. No general
addresses or synchronous actions may occur in the same block. These G functions are:
G25, G26: Working area and spindle speed limitation
G110, G111, G112: Pole programming with polar coordinates
G92: Spindle speed limitation with v constant
STARTFIFO, STOPFIFO: Control of preprocessing buffer
E.g. G4 F1000 M100: no M function allowed in the G4 block.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Program G function by itself in the block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12130
Channel %1 block %2 illegal tool orientation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The tool orientation may only be contained in a modal motion block or in a WAB block
(repositioning).
It can be programmed via Euler angles (A1, B1, C1), normal vector components (A2, B2,
C2), direction vectors (A3, B3, C3) or the axis end values. If the tool orientation is pro-
grammed in conjunction with the functions:
G04 (dwell time), G33 (thread cutting with constant lead), G74 (approach reference
points) or REPOSL, REPOSQ, REPOSH (repositioning)
then an alarm is issued with Euler angles, direction vectors and normal vector compo-
nents.
Reactions: - Correction block
- Interface signals are set.
- Alarm display.
Remedy: Press the NC Stop key and select the function "Correction block" with the softkey PRO-
GRAM CORRECT. The correction pointer positions on the incorrect block.
Program tool orientation with the axis end values or use a separate block for this.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
12140
Channel %1 block %2 functionality %3 not implemented
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Software construct in the source text
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-145