Siemens SINUMERIK 840D sl Series Diagnostics Manual page 256

Overview of Alarms
- Interface signals are set.
- Alarm display.
Remedy: Program the lifting direction under ALF=... within the permissible limits.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16005
Channel %1 block %2 invalid value for lifting distance
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Mistake in programming: the value for the lifting path must not be negative.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16010
Channel %1 block %2 machining stop after lift fast
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: LIFTFAST without interrupt routine (Asup) has been programmed. The channel is
stopped after the lift motion has been carried out.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: After the channel stop, the axes must be retracted manually in JOG and the program
aborted with Reset.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16015
Channel %1 block %2 wrong axis identifier %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: Axis names from different coordinate systems were used to program axes for LIFTFAST.
The retraction movement is no longer clear.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Use axis names from one coordinate system.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16016
Channel %1 block %2 no retraction position programmed for axis %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: The retraction enable was programmed for LIFTFAST without defining a retraction posi-
tion for the axis. The retraction movement is no longer clear.
Reactions: - Correction block is reorganized.
2-256
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005