Siemens SINUMERIK 840D sl Series Diagnostics Manual page 471

08/2005
61261
Channel %1 block %2: center offset too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The center offset on center drilling is larger than permissible.
Alarm triggered by following cycles: F_DRILL, F_DRILLD.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Enter smaller center offset (see display machine data 9862).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61262
Channel %1 block %2: lead not possible with selected tool
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The lead of the tap does not match the programmed lead.
Alarm triggered by following cycles: F_DR_TAP, F_DRM_TA, F_TAP.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Use a tap with the programmed lead.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61263
Channel %1 Block %2: Chained ShopMill program blocks not permissible in sub-
program on pos. pattern
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a
position pattern.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Reprogram machining.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61264
Channel %1 Block %2: Chained ShopTurn program blocks not permissible in sub-
program on pos. pattern
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a
position pattern.
Alarm triggered by following cycle: F_MANAGE.
Reactions: - Interpreter stop
- NC Start disable in this channel.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-471