Siemens SINUMERIK 840D sl Series Diagnostics Manual page 437

08/2005
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840, CYCLE96, CYCLE97.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Check parameter for the thread size or setting for the lead (contradict each other).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61002
Channel %1 block %2: Type of machining incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The value of the VARI parameter for the machining has been incorrectly specified. Alarm
triggered by following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, CYCLE71,
CYCLE72, CYCLE76, CYCLE77, CYCLE93, CYCLE95, CYCLE97, CYCLE98.
Remedy: Modify VARI parameter.
61003
Channel %1 Block %2: No feed programmed in cycle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameter for the feed has been incorrectly specified. Alarm triggered by following
cycles: CYCLE71, CYCLE72.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Modify feed parameter.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61004
Channel %1 Block %2: Incorrect configuration of geometry axes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The geometry-axes sequence is wrong. CYCLE328
Reactions: - Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61005
Channel %1 Block %2: 3rd geometry axis not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: With an application on the lathe with no Y-axis in the G18 plane. Alarm triggered by fol-
lowing cycle: CYCLE86.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: --
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-437