Siemens SINUMERIK 840D sl Series Diagnostics Manual page 312

Overview of Alarms
Definitions: In the displayed block, an axis is programmed for the fixed point approach (G75) that is
involved in the active transformation. Fixed point approach is not performed with this axis!
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Remove G75 instruction from the part program block or previously deselect transforma-
tion with TRAFOOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17630
Channel %1 block %2 referencing for transformed axis %3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In the displayed block, an axis is programmed for reference point approach (G74) that is
involved in the active transformation. Reference point approach is not performed with this
axis!
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Remove G74 instruction, or the machine axes involved in transformation, from the part
program block or previously deselect the transformation with TRAFOOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17640
Channel %1 block %2 spindle operation for transformed axis %3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The axis programmed for the spindle operation is involved in the current transformation
as geometry axis. This is not allowed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: First switch off the transformation function.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17650
Channel %1 block %2 machine axis %3 not programmable
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The machine axis cannot be used in an active transformation. You may be able to pro-
gram the function in a different coordinate system. For example, it may be possible to
specify the retraction position in the basic coordinate system or the workpiece coordinate
system. The axis identifier is used to select the coordinate system.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Deactivate the transformation or use another coordinate system.
2-312
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005