Siemens SINUMERIK 840D sl Series Diagnostics Manual page 450

Overview of Alarms
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61135
Channel %1 block %2: parameter for sequence of interpol./individ. axis movement
incorrect
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61136
Channel %1 block %2: No 3rd geo axis in variable _SCW_N[] agreed.
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61137
Channel %1 block %2: TOOLCARR (swivel function) and cycle W axis exclude one
another (due to workpiece reference $WPFRAME).
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE69.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61138
Channel %1 block %2: parameter %4 incorrectly defined for tool monitoring in
cycles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions:
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
2-450
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005