Siemens SINUMERIK 840D sl Series Diagnostics Manual page 822

Overview of Alarms
• Modify MD 13010: DRIVE_LOGIC_NR
• Modify MD 13020: DRIVE_INVERTER_CODE
• Modify MD 13030: DRIVE_MODULE_TYPE
• Modify MD 13040: DRIVE_TYPE
• MDs for the setpoint/actual-value assignment:
• Modify MD 30110: CTRLOUT_MODULE_NR
• Modify MD 30130: CTRLOUT_TYPE
• Modify MD 30220: ENC_MODULE_NR
• Modify MD 30230: ENC_INPUT_NR
• Modify MD 30240: ENC_TYPE
It might be necessary to first declare an NC axis in the channel for this drive (MD 20070
AXCONF_MACHAX_USED = K, [K ...channel axis no.]).
Program Con- Switch control OFF - ON.
tinuation:
300011
Axis %1 drive %2 hardware version of spindle not supported
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: An old spindle power section (so-called 186-HSA) is connected to the drive bus. This
spindle drive is not supported by SINUMERIK 840D. Ramp-up is interrupted.
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. A DSP spindle module must
be ordered and fitted.
Program Con- Switch control OFF - ON.
tinuation:
300012
Axis %1 drive %2 hardware version of control module not supported
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: There is a drive module with an "old" control module on the drive bus. 810D does not sup-
port these modules. Ramp-up is interrupted.
Reactions: - NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Order standard or perfor-
mance control module and exchange with "old".
Program Con- Switch control OFF - ON.
tinuation:
300020
Drive %1 removed for diagnostics
Parameters: %1 = Drive number
2-822
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005