Remedy: Check Parameter - Siemens SINUMERIK 840D sl Series Diagnostics Manual

08/2005
Remedy: --
Program Con- Internal
tinuation:
61803
Channel %1 block %2: Programmed axis not available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed axis is not in the system.
Alarm triggered by following cycles: CYCLE83, CYCLE84, CYCLE840.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Check parameter _AXN.
Check MD20050-20080.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61804
Channel %1 block %2: Progr. position exceeds reference point
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed intermediate position or actual position is behind the reference point.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61805
Channel %1 block %2: Value programmed absolute and incremental
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed intermediate position is both absolutely as well as incrementally pro-
grammed.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: --
Program Con- Internal
tinuation:
61806
Channel %1 block %2: Wrong axis assignment
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The axis-assignment sequence is wrong.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-501