Siemens SINUMERIK 840D sl Series Diagnostics Manual page 96

Overview of Alarms
10258
[up to SW 3.x only] Mode group %2 channel %1: ID invalid or duplicated
Parameters: %1 = Channel number
%2 = Mode group number
Definitions: An invalid channel/mode group assignment was detected on power-up.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Check machine data ASSIGN_CHAN_TO_MODE_GROUP.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
10259
[up to SW 3.x only] Channel %1
Parameters: %1 = Channel number
Definitions: REORG is not possible at present.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: --
Program Con- Switch control OFF - ON.
tinuation:
10260
[up to SW 3.x only] Channel %1
Parameters: %1 = Channel number
Definitions: REORG is not possible at present.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: --
Program Con- Switch control OFF - ON.
tinuation:
10261
Channel %1 communication overload for block preparation
Parameters: %1 = Channel number
Definitions: The internal communication between the NCK modules that evaluate the channel-specific
VDI signals (START/STOP/RESET/DDTG/ASUBS/...) and the block preparation are over-
loaded. The block preparation modules are not being allocated enough computing time.
Reactions: - NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
2-96
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005