Siemens SINUMERIK 840D sl Series Diagnostics Manual page 424

Overview of Alarms
Remedy: Correct the MD.
Program Con- Switch control OFF - ON.
tinuation:
27220
PROFIsafe: Number of NCK F modules (%1) <> Number of S7 F modules (%2)
Parameters: %1 = Number of parameterized NCK F modules
%2 = Number of parameterized S7 F modules
Definitions: The number of F modules parameterized via the NCK machine data
$MN_PROFISAFE_IN/OUT_ADDRESS is:
• Greater than the number of PROFIBUS slaves in the S7 PROFIBUS configuration.
• Smaller than the number of F modules in the S7 PROFIBUS configuration,
• greater than the number of F modules known in the S7 PROFIBUS configuration.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Check the F parameterization in MD $MN_PROFISAFE_IN/OUT_ADDRESS.
Check the F configuration in the S7 PROFIBUS configuration.
Check the parameterized PROFIsafe master address in MD
$MN_PROFISAFE_MASTER_ADDRESS and in the S7 PROFIBUS configuration.
Program Con- Switch control OFF - ON.
tinuation:
27221
PROFIsafe: NCK F module MD %1[%2] unknown
Parameters: %1 = MD name
%2 = MD array index
Definitions: The F module parameterized in the specified machine data is unknown under this
PROFIsafe address in the S7 PROFIBUS configuration.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Check the PROFIsafe addresses in the NCK MD and S7 PROFIBUS configuration.
Program Con- Switch control OFF - ON.
tinuation:
27222
PROFIsafe: S7 F module PROFIsafe address %1 unknown
Parameters: %1 = PROFIsafe address
Definitions: The F module with the specified PROFIsafe address has not been parameterized as an F
module in the NCK MD.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
2-424
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005