Siemens SINUMERIK 840D sl Series Diagnostics Manual page 94

Overview of Alarms
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Press RESET and select the mode again.
Program Con- Clear alarm with the RESET key in all channels of this mode group. Restart part program.
tinuation:
10250
[up to SW 3.x only] Channel %1 reorganization of block processing not possible at
this time
Parameters: %1 = Channel number
Definitions: REORG is not possible at present.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10251
[up to SW 3.x only] Channel %1
Parameters: %1 = Channel number
Definitions: REORG is not possible at present.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10252
[up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10253
[up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
2-94
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005