Siemens SINUMERIK 840D sl Series Diagnostics Manual page 181

08/2005
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14021
Channel %1 block %2 wrong value or wrong number of parameters on function or
procedure call
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: • An illegal parameter value was specified in a function or procedure call.
• An illegal number of actual parameters was programmed in a function or procedure call.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14025
Channel %1 block %2 motion synchronous action: illegal modal ID
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In modal motion synchronous actions an illegal ID number has been assigned.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14026
Channel %1 block %2 motion synchronous action: invalid polynomial number in
the FCTDEF command
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An FCTDEF command was programmed with a polynomial number that exceeds the
maximum value set in $MC_MM_NUM_FCTDEF_ELEMENTS.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
14030
Channel %1 block %2 combine OSCILL and POSP during oscillation with infeedmo-
tion
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-181