Siemens SINUMERIK 840D sl Series Diagnostics Manual page 311

08/2005
Definitions: The displayed axis is involved in the current transformation. This means that is it not pos-
sible to set the actual value memory (preset) for this axis.
Example:
Machine axis A should be set to the new actual value A 100 at the absolute position A
300.
:
N100 G90 G00 A=300
N101 PRESETON A=100
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Avoid preset actual value memory for axes which are participating in a transformation or
deselect the transformation with the keyword TRAFOOF.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17605
Channel %1 block %2 axis %3 transformation active: inhibits rotation of axis con-
tainer
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The programmed axis/spindle is active in a transformation and the axis container cannot
be rotated for this reason.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program. Deactivate the transformation for this axis/spindle before rotating
the axis container or perform the axis container rotation later.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17610
Channel %1 block %2 axis %3 involved in the transformation, action cannot be car-
ried out
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: The axis is involved in the active transformation. It can therefore not execute the
demanded action, traversing as positioning axis, enable for axis replacement.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Deselect the transformation with TRAFOOF ahead of time or remove the action from the
part program block
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
17620
Channel %1 block %2 approaching fixed point for transformed axis %3 not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-311