Siemens SINUMERIK 840D sl Series Diagnostics Manual page 321

08/2005
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18313
Channel %1 block %2 frame: illegal switchover of geometry axes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not allowed to change the geometry axis assignment because the current frame con-
tains rotations.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Change NC program or set other mode with $MN_FRAME_GEOAX_CHANGE_MODE.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18314
Channel %1 block %2 frame: type conflict
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: It is not possible to chain global frames and channel-specific frames. The alarm occurs if
a global frame is programmed with a channel axis name and no machine axis on this
NCU is assigned to the channel axis. Channel-specific frames cannot be programmed
with machine axis names if there is no corresponding channel axis on this NCU.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18400
Channel %1 block %2 language change not possible:%3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Cause
Definitions: The selection of an external NC language is not possible due to the reason specified. The
following reasons are possible (see parameter 3):
1. Invalid machine data settings
2. Active transformation
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Remedy the specified cause of the error before selecting the language.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
20000
Channel %1 axis %2 reference cam not reached
Parameters: %1 = Channel number
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-321