Siemens SINUMERIK 840D sl Series Diagnostics Manual page 90

Overview of Alarms
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10206
[up to SW 3.x only] Channel %1 general error in function generator
Parameters: %1 = Channel number
Definitions: An error has occurred during activation/deactivation of the function generator.
Reactions: - Alarm display.
Remedy: Press RESET.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10207
Channel %1 error when selecting or deselecting the digitize function
Parameters: %1 = Channel number
Definitions: An error has occurred on activating/deactivating the digitizing module; e.g. not in channel
ready state, already activated, etc.
Reactions: - Alarm display.
Remedy: Press RESET.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
10208
Channel %1 continue program with NC start
Parameters: %1 = Channel number
Definitions: After block search with calculation, the control is in the desired state. The program can
now be started with NC Start or the state can be changed for the time being with over-
store/jog.
Reactions: - Interpreter stop
- Alarm display.
- NC Stop on alarm.
Remedy: Press NC Start.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10209
Channel %1 internal NC stop after block search
Parameters: %1 = Channel number
Definitions: Internal alarm which initiates an NC Stop. The alarm is output if
$MN_SEARCH_RUN_MODE ==1 and the last action block is activated after block search
in the main run. Alarm 10208 is activated depending on the VDI signal PLC -> NCK chan-
nel DBB1.6.
Reactions: - Interpreter stop
- NC Stop on alarm.
Remedy: NC-Start
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10220
[up to SW 3.x only] Channel %1 active
Parameters: %1 = Channel number
Definitions: The internal command "delete NC blocks prepared by preprocessor and reorganize
(REORG)" has been requested for this channel. It is initiated, e.g. as a result of an over-
store, but cannot be executed in a running channel.
Reactions: - Alarm display.
Remedy: Stop the channel (NC Stop) and repeat the action.
2-90
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005