Siemens SINUMERIK 840D sl Series Diagnostics Manual page 127

08/2005
10805
Channel %1 block %2 repositioning after switch of geometry axes or transforma-
tion
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the asynchronous subroutine the assignment of geometry axes to channel axes was
changed or the active transformation modified.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10810
Channel %1 block %2 master spindle not defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The function "Revolutional feedrate" (with G95 or G96), or "Rigid tapping" (with
G331/G332) has been programmed, although no master spindle is defined from which the
speed could be derived. For the definition the MD 20090 SPIND_DEF_MASTER_SPIND
is available for the default or the keyword SETMS in the part program, thus allowing each
spindle of the channel to be redefined as master spindle.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Remedy: Preset the master spindle with MD 20090 SPIND_DEF_MASTER_SPIND[n]=m (n ...
channel index, m ... spindel no.) or define it with an identifier in an NC part program before
a G function that requires a master spindle is programmed.
The machine axis that is to be operated as a spindle must be equipped in MD 35000
SPIND_ASSIGN_TO_MACHAX[n]=m (n ... machine axis index, m ... spindle no.) with a
spindle number. Additionally, the MD 20070 AXCONF_MACHAX_USED[n]=m (n ... chan-
nel axis index, m ... machine axis index) must be used to assign it to a channel (channel
axis index 1 or 2).
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10820
Channel %1 rotary axis/spindle %2 not defined
Parameters: %1 = Channel number
%2 = Axis name, spindle number
Definitions: Revolutional feed has been programmed for contouring and synchronous axes or for an
axis/spindle. However, the rotary axis/spindle from which the feed is to be deduced is not
available.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
Remedy: Correct part program or set the setting data 43300 ASSIGN_FEED_PER_REV_SOURCE
correctly.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-127