Siemens SINUMERIK 840D sl Series Diagnostics Manual page 599

08/2005
Reactions: - Alarm display.
Remedy: Approach reference point.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112350
No swivel data created!
Definitions: There are no swivel data blocks.
Reactions: - Alarm display.
Remedy: Set up swivel data blocks (see /FBSP/, ShopMill Description of Functions)
Program Con- Internal
tinuation:
112360
Step was not transferred into program chain%nas program run active.
Definitions: The program that you want to change is being executed in the operating mode "Machine
auto". You can only change programs that are not being executed in the operating mode
"Machine auto".
Reactions: - Alarm display.
Remedy: Stop the program run in the "Machine auto" operating mode.
Program Con- Internal
tinuation:
112400
Not stored in the Tool Management:%n%1 Program: %2
Definitions: The tool specified in the program does not exist.
Reactions: - Alarm display.
Remedy: The tool must be created before the data is saved.
Program Con- Internal
tinuation:
112401
Tool could not be set up:%n%1
Definitions: When reading in the tool data, a tool could not be created.
Reactions: - Alarm display.
Remedy: Check tool management.
Program Con- Internal
tinuation:
112402
Work offsets: error on writing
Definitions: Data could not be written to the NC.
Reactions: - Alarm display.
Remedy: Should the alarm be displayed again after a new try, please contact the hotline of Sie-
mens AG, A&D MC.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
112420
Error on changing over inch/metric!%nCheck all data!
Definitions: The switchover of the data for the inch/metric conversion was not completed.
This alarm can only appear in the event of hardware defects.
Reactions: - NC Start disable in this channel.
- Alarm display.
Remedy: The following data must be checked:
Display MD's:
MD9655: $MM_CMM_CYC_PECKING_DIST
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-599