Siemens SINUMERIK 840D sl Series Diagnostics Manual page 264

Overview of Alarms
Remedy: Values for chamfers, roundings and modal roundings must be programmed with positive
values only.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16510
Channel %1 block %2 no facing axis available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Diameter programming has been activated with the keyword DIAMON although no facing
axis has been programmed in this NC block.
If the diameter axis is not a geometry axis, in the initial setting "DIAMON" the alarm
appears as soon as the control is switched on.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Activate the modal G func-
tion DIAMON only in NC blocks containing a facing axis or deactivate diameter program
with DIAMOF.
In machine data 20150 GCODE_RESET_VALUES[28] select "DIAMOF" for the initial set-
ting.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16600
Channel %1 block %2 spindle %3 gear stage change not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Spindle number
Definitions: The programmed speed is outside the speed range of the set gear stage. In order to exe-
cute the programmed speed, the gear stage must be changed. In order to be able to exe-
cute the automatic gear stage change (M40 is active), the spindle must be in speed
control operation.
>The alarm will no longer be output after having set bit 30 (0x40000000) in MD 11410
SUPPRESS_ALARM_MASK. However, the function will not be affected by this.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: The changeover to speed control operation is performed by programming M3, M4 or M5.
The M functions can be written together with the S word in the same block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16700
Channel %1 block %2 axis %3 invalid feed type
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: In a thread cutting function, the feed has been programmed in a unit that is impermissible.
1. G33 (thread with constant lead) and the feed have not been programmed with G94 or
G95.
2. G33 (thread with constant lead) is active (modal) and G63 is programmed additionally
in a following block .conflict situation! (G63 is in the 2nd G group, G33, G331 and G332
are in the 1st G group).
3. G331 or G332 (rigid tapping) and the feed have not been programmed with G94.
2-264
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005