Siemens SINUMERIK 840D sl Series Diagnostics Manual page 229

08/2005
%3 = Identifier
Definitions: To process motion synchronous actions resources are required. They are configured via
the machine data $MC_MM_IPO_BUFFER_SIZE, $MC_MM_NUM_BLOCKS_IN_PREP
and $MC_MM_NUM_SYNC_ELEMENTS. If these resources are insufficient for executing
the part program, then this alarm is issued. The parameter %3 shows which resource has
run out:
Increase identifier <= 2: $MC_MM_IPO_BUFFER_SIZE or
$MC_MM_NUM_BLOCKS_IN_PREP.
Increase identifier > 2: $MC_MM_NUM_SYNC_ELEMENTS.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Correct part program or increase resources.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14752
Channel %1 block %2 DELDTG | STOPREOF conflict
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In a block of motion synchronous actions referring to a motion block, both DELDTG
(delete distance-to-go) and STOPREOF (preprocessing stop) have been programmed.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: The functions DELDTG and STOPREOF exclude each other in a block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14753
Channel %1 block %2 motion synchronous actions with illegal interpolation type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active interpolation type (e.g. 5-axis interpolation) is not allowed for the motion syn-
chronous action or for the function "Several feeds".
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14754
Channel %1 block %2 motion synchronous actions and wrong feed type
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The active feed type is not allowed for the motion synchronous action or for the function
"Several feeds".
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-229