Siemens SINUMERIK 840D sl Series Diagnostics Manual page 457

08/2005
- Interface signals are set.
- Alarm display.
Remedy: Sort the sequence in the machining block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61202
Channel %1 block %2: No technology cycle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No technology cycle was programmed in the machining block.
Alarm triggered by following cycles: E_MANAGE, F_MANAGE.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Program a technology block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61203
Channel %1 block %2: No position cycle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No positioning cycle was programmed in the machining block.
Alarm triggered by following cycles: E_MANAGE, F_MANAGE.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Program positioning block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61204
Channel %1 block %2: Technology cycle unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified technology cycle in the machining block is unknown.
Alarm triggered by following cycles: E_MANAGE, F_MANAGE.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Delete and reprogram the technology block.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61205
Channel %1 block %2: Position cycle unknown
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The specified positioning cycle in the machining block is unknown. Alarm triggered by fol-
lowing cycles: E_MANAGE, F_MANAGE.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-457