Siemens SINUMERIK 840D sl Series Diagnostics Manual page 555

08/2005
101148
Controller MD calculated
Definitions: Calculating the controller data in the start-up area, image drive machine data, was suc-
cessful.
Remedy: --
101149
Display MD accepted
Definitions: --
Remedy: --
101150
MD set to active
Definitions: Activation of the machine data in the start-up area, machine data images, was successful.
Remedy: --
101151
Start-up successful
Definitions: In the start-up area, image NC start-up, one of the three functions
• normal booting
• booting with default values
• start of the software update
was successfully initiated.
Remedy: --
101152
Error during communication with NCK
Definitions: --
Remedy: --
101153
Erroneous HMI NCK communication %1 %2
Parameters: %1 = Error class
%2 = Error code
Definitions: In the start-up area the softkey "Calculate controller data", for example, was pressed.
An unspecific error message is sent from the NCK or drive as acknowledgement for this
function call.
By using the two hexadecimal values (error class, error code), the start-up engineer can
perform an error diagnostics.
Remedy: --
101154
PI service refused
Definitions: The current status of the NKC/drive does not permit the function that was selected.
Remedy: See the Installation and Start-up Guide.
101155
Path %1 does not exist
Parameters: %1 = Path
Definitions: During a file function, e.g.saving boot files, an attempt was made to access a non-existent
path.
Remedy: Switch the control OFF/ON or see the Installation and Start-up Guide.
101156
Function impermissible
Definitions: The selected function is impermissible.
Remedy: See the Installation and Start-up Guide.
101157
File %1 does not exist
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-555