Siemens SINUMERIK 840D sl Series Diagnostics Manual page 423

08/2005
27206
PROFIsafe: MD %1[%2] maximum number of F user data (%3 bits) exceeded.
Parameters: %1 = MD name
%2 = MD array index for MD name
%3 = Maximum F user data bits.
Definitions: The parameterized data indicated in the machine data are outside the F user data range
of the F module.
Note
When machine data PROFISAFE_IN/OUT_ADDRESS is displayed, the sub slot address
parameterized in it will exceed the F user data range of the F module.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Correct the MD.
Program Con- Switch control OFF - ON.
tinuation:
27207
PROFIsafe: MD %1[%2] max. sub slot number: %3 exceeded
Parameters: %1 = MD name
%2 = MD array index for MD name
%3 = Max. number of sub slots
Definitions: The sub slot parameterized in the indicated machine data exceeds the max. permissible
number of sub slots per PROFIsafe module.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Reduce the number of sub slots by changing the splitting of F user data of the PROFIsafe
module.
Program Con- Switch control OFF - ON.
tinuation:
27208
PROFIsafe: MD %1[%2]: max. sub-slot address %3 exceeded.
Parameters: %1 = MD name
%2 = MD array index
%3 = Maximum sub-slot address.
Definitions: A sub-slot address was entered in the MD that is too high. The entered value must not
exceed the displayed maximum sub-slot address.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-423