Siemens SINUMERIK 840D sl Series Diagnostics Manual page 574

Overview of Alarms
Remedy: --
105007
No name entered
Definitions: --
Remedy: Wait until the loading procedure is terminated.
105008
Write memory error on cycle call
Definitions: The resources of the MMC100 are exhausted.
No more dynamic memory available.
Remedy: --
105009
No write access to data
Definitions: The file is write-protected.
Remedy: --
105010
No data selected
Definitions: The cursor is not placed on a valid file name.
Remedy: --
105011
Cycles overview %1 not available
Parameters: %1 = --
Definitions: The cycle description sc.com was not found in the NCK file system.
Remedy: --
105012
Program not or only partially editable (NC Reset)
Definitions: The selected program is currently being executed.
Remedy: --
105013
Copied data can be inserted with SK 'Paste'
Definitions: The copied data is in the clipboard and can be inserted anywhere via the softkey "Paste".
Remedy: --
105014
Error on copying ! %1
Parameters: %1 = --
Definitions: The file could not be copied.
Remedy: --
105015
Error on renaming ! %1
Parameters: %1 = --
Definitions: The file could not be renamed.
Remedy: --
105016
Error on deleting ! %1
Parameters: %1 = --
Definitions: The file could not be deleted.
Remedy: --
105017
Selection possible only after enable or in RESET state %1
Parameters: %1 = --
Definitions: The selected program is either being currently executed or was not yet enabled.
Remedy: --
2-574
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005