Siemens SINUMERIK 840D sl Series Diagnostics Manual page 234

Overview of Alarms
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
14770
Channel %1 block %2 auxiliary function programmed incorrectly
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The permissible number of programmed auxiliary functions per NC block has been
exceeded or more than one auxiliary function of the same auxiliary function group has
been programmed (M and S function).
In the user-defined auxiliary functions, the maximum number of auxiliary functions per
group in the NCK system settings has been defined for all auxiliary functions by means of
the machine data 11100 AUXFU_MAXNUM_GROUP_ASSIGN (default: 1)
For each user-defined auxiliary function to be assigned to a group, the assignment is
effected through 4 channel-specific machine data.
Return jump from asynchronous subprogram with M02/M17/M30, whereby the M code is
not alone in the block. This is impermissible if the asynchronous subprogram interrupts a
block with WAITE, WAITM or WAITMC. Remedy: Program M02/M17/M30 alone in the
block or replace via RET.
22010 AUXFU_ASSIGN_TYPE: type of auxiliary function, e.g. M
22000 AUXFU_ASSIGN_GROUP: required group
22020 AUXFU_ASSIGN_EXTENSION: any required extension
22030 AUXFU_ASSIGN_VALUE: function value
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Correct the part program - max. 16 auxiliary functions, max. 5 M functions per NC block,
max. 1 auxiliary function per group.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14780
Channel %1 block %2 unreleased option used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-released option has been used in the block.
Brief identification description
1 LaserCtrl option
2 ClearCtrl option
3 FeedAdapt option
4 AaTOff option
5 Tang option
6 LeadCtab option
7 ELG option
8 Trafo5 option
9 Traoem option
10 Transmit option
11 Tracon option
12 Tracyl option
13 Traang option
14 Oscill option
2-234
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005