Siemens SINUMERIK 840D sl Series Diagnostics Manual page 87

08/2005
- Interface signals are set.
- Alarm display.
Remedy: • Buy option
• Set (current/speed controller) cycle times to 810D default values.
Program Con- Switch control OFF - ON.
tinuation:
8050
Option 'PLC inputs/outputs' has not been set.
Definitions: The number of PLC I/Os has not been set in the option date for Solution Line.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select area SI Basic or SI Comfort in the option date.
Program Con- Switch control OFF - ON.
tinuation:
8080
%1 options are activated without setting the license key
Parameters: %1 = Number of non-licensed options
Definitions: An option was activated but no license key set to prove the purchase of the option.
Reactions: - Alarm display.
Remedy: Generate and enter license key via Internet.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
8081
%1 options are activated that are not licensed by the license key
Parameters: %1 = Number of non-licensed options
Definitions: Options were activated, that are not licensed by the license key entered.
Reactions: - Alarm display.
Remedy: Generate and enter license key via Internet.
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
8082
The license key was entered three times, Power On required before next try.
Definitions: The license can be entered three times max (correctly or incorrectly).
Reactions: - Alarm display.
Remedy: Execute NCK Power On and enter the license key (correctly).
Program Con- Clear alarm with the Delete key or NC START.
tinuation:
8088
'Selection of non-grinding-specific tools' option not possible
Definitions: The system version of the software only allows selection of grinding specific tools (i.e.
tools of type 4xx).
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select a tool of type 4xx (grinding tool)
or install a standard version of the system software
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-87