Siemens SINUMERIK 840D sl Series Diagnostics Manual page 468

Overview of Alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61250
Channel %1 block %2: Width across flats/edge length too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The width across flats/edge length is too small.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Increase key width/edge length.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61251
Channel %1 block %2: Width across flats/edge length too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The width across flats/edge length is too large.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Decrease key width/edge length.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61252
Channel %1 block %2: Chamfer/radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Chamfer/radius is too large.
Alarm triggered by following cycle: CYCLE79.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Decrease chamfer/radius.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61253
Channel %1 Block %2: No finishing allowance programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No finishing allowance has been entered.
Alarm triggered by following cycles: E_PO_CIR, E_PO_REC, E_SL_CIR, E_SL_LON,
F_PO_CIR, F_PO_REC, F_SL_CIR, F_SL_LON.
Reactions: - Interpreter stop
- NC Start disable in this channel.
2-468
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005