Siemens SINUMERIK 840D sl Series Diagnostics Manual page 476

Overview of Alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61280
Channel %1 Block %2: Mirroring in WO %4 missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: If the program starts with a counterspindle movement, a work offset with mirroring will
have to be selected.
Alarm triggered by following cycle: F_SUB_SP
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Select the mirroring for the work offset used.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61281
Channel %1 block %2: starting point of machining outside retraction planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The starting point of machining is outside the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Adjust the retraction planes.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61282
Channel %1 block %2: end point of machining outside retraction planes
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The end point of machining is outside the retraction planes.
Alarm triggered by following cycle: F_SP_RP.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Adjust the retraction planes.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61283
Channel %1 block %2: direct approach not possible, as tool change required
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: After block search a position is to be reached by direct approach, but a tool change is
required before.
Alarm triggered by following cycle: F_TFS.
Reactions: - Interpreter stop
2-476
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005