Block Number, Label Channel Number; Remedy: Check Parameter; Parameters: %1 = Channel Number - Siemens SINUMERIK 840D sl Series Diagnostics Manual
Hide thumbs
Also See for SINUMERIK 840D sl Series:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
08/2005
Definitions:
The starting point reached before the cycle call does not lie outside the rectangle
described by the contour subroutine. Alarm triggered by following cycle: CYCLE95.
Remedy:
Check starting point prior to cycle call.
61608
Channel %1 block %2: Incorrect tool point direction programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE94, CYCLE96.
Reactions:
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
A cutting edge position 1...4, matching the undercut form, must be programmed.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61609
Channel %1 block %2: Shape incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE94, CYCLE96, LONGHOLE, POCKET3,
SLOT1.
Remedy:
Check parameter for the undercut form or groove form or pocket.
61610
Channel %1 Block %2: No infeed depth programmed
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE76, CYCLE77, CYCLE96.
Remedy:
Check parameter MID.
61611
Channel %1 Block %2: No point of intersection found
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
No intersection could be calculated with the contour. Alarm triggered by following cycle:
CYCLE95.
Reactions:
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy:
Check contour programming or modify infeed depth.
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61612
Channel %1 block %2: Thread finishing not possible
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE97, CYCLE98.
Remedy:
Check the conditions for thread finishing.
61613
Channel %1 block %2: Undercut position incorrectly defined
Parameters:
%1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-493
Hide quick links:
Advertisement
Chapters
Table of Contents
