Siemens SINUMERIK 840D sl Series Diagnostics Manual page 95

08/2005
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10254
[up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Interpreter output negative acknowledgement for REORG.
Reactions: - Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10255
[up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present.
Reactions: - Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10256
[up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present - program abort.
Reactions: - Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
10257
[up to SW 3.x only] Channel %1 reorg sequence canceled
Parameters: %1 = Channel number
Definitions: Internal sequence error. REORG is not possible at present - program abort.
Reactions: - Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Press RESET.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-95