Siemens SINUMERIK 840D sl Series Diagnostics Manual page 442

Overview of Alarms
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61102
Channel %1 block %2: No spindle direction programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE86, CYCLE87, CYCLE88, CYCLE840,
POCKET3, POCKET4.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Parameter SDIR (or SDR in CYCLE840) must be programmed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61103
Channel %1 block %2: Number of holes is zero
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No value for the number of holes has been programmed. Alarm triggered by following
cycles: HOLES1, HOLES2.
Remedy: Check parameter NUM.
61104
Channel %1 block %2: Contour violation of slots
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Incorrect parameterization of the milling pattern in the parameters which define the posi-
tion of the slots/elongated holes on the circle and their form. Alarm triggered by following
cycles: SLOT1, SLOT2, LONGHOLE.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: --
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61105
Channel %1 block %2: Milling cutter radius too large
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The diameter of the cutter used is too large for the form to be machined. Alarm triggered
by following cycles: SLOT1, SLOT2, POCKET1 to POCKET4, LONGHOLE, CYCLE90.
Reactions: - Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Remedy: Either a tool with a smaller radius has to be used or the contour must be modified.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61106
Channel %1 block %2: Number of or distance between circular elements
2-442
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005