Siemens SINUMERIK 840D sl Series Diagnostics Manual page 255

08/2005
are allowed, whether the probe is actually connected or not.
Example:
N10 MEAW=2 G01 X100 Y200 Z300 F1000
Probe 2 without deletion of distance-to-go
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Include a probe number within the limits given above in the keyword MEAW=... This must
correspond to the hardware connection of the probe.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
15950
Channel %1 block %2 no traverse motion programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Measure with deletion of distance-to-go
In the part program, no axis or a traversing path of zero has been programmed with the
command MEAS (measure with deletion of distance-to-go).
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Correct the part program and add the axis address or the traversing path to the measure-
ments block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
15960
Channel %1 block %2 no traverse motion programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Measure without deletion of distance-to-go
In the part program, no axis or a traversing path of zero has been programmed with the
command MEAW (measure without deletion of distance-to-go).
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Correct the part program and add the axis address or the traversing path to the measure-
ments block.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16000
Channel %1 block %2 invalid value for lifting direction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During the "rapid lift from contour" (keyword: LIFTFAST), a code value for the lifting direc-
tion (keyword: ALF=...) which lies outside the permissible range (permissible value range:
0 to 8) was programmed .
With active cutter radius compensation:
Code numbers 2, 3 and 4 cannot be used in G41
Code numbers 6, 7 and 8 cannot be used in G42 because they code the direction to the
contour.
Reactions: - Correction block is reorganized.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-255