Siemens SINUMERIK 840D sl Series Diagnostics Manual page 475

08/2005
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Outer tool diameter required in case of delimitations.
Alarm triggered by following cycle: CYCLE61.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Specify the outer tool diameter.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61277
Channel %1 block %2: Tool diameter larger than restriction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Tool diameter larger than delimitation.
Alarm triggered by following cycle: CYCLE61.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Use a smaller tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61278
Channel %1 block %2: If tool angle is larger than 90°, both tool diameters must be
equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For tool angles larger than 90°, the two tool diameters must be identical.
Alarm triggered by following cycle: CYCLE61.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct the tool angle or the tool diameters.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61279
Channel %1 block %2: If tool angle equals 90°, both tool diameters must be equal
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: For tool angles equal to 90°, the two tool diameters must be identical.
Alarm triggered by following cycle: CYCLE61.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Correct the tool angle or the tool diameters.
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-475