Siemens SINUMERIK 840D sl Series Diagnostics Manual page 716

Overview of Alarms
Remedy: The number of channels set in p8740 must be greater than or equal to the number of
PDOs.
There are 2 possibilities:
Increase the number of channels in p8740 and confirm the selection using p8741.
Reduce the number of PDOs by setting the COB-ID to invalid.
208759 <location>CBC: PDO COB-ID already available
Reaction: NONE
Acknowledge: NONE
Cause: An existing PDO COB-ID was allocated.
Remedy: Select another PDO COB-ID.
213000 <location>License not adequate
Reaction: NONE
Acknowledge: NONE
Cause: - for the drive unit, the options that require a license are being used but the licenses are
not sufficient.
- an error occurred when checking the existing licenses.
Alarm value (r2124, decimal):
0:
The existing license is not sufficient.
1:
An adequate license was not able to be determined as the CompactFlash Card with the
required licensing data was withdrawn in operation.
2:
An adequate license was not able to be determined, as an error occurred when reading-
out the required licensing data from the CompactFlash Card.
3:
An adequate license was not able to be determined as there is a checksum error in the
license key.
4:
An internal error occurred when checking the license.
Remedy: Alarm value 0:
Additional licenses are required and these must be activated (p9920, p9921).
Alarm value 1:
With the system powered-down, re-insert the CompactFlash Card that matches the
system.
Alarm value 2:
Enter and activate the license key (p9920, p9921).
Alarm value 3:
Compare the license key (p9920) entered with the license key on the certificate of license.
Re-enter the license key and activate (p9920, p9921).
Alarm value 4:
- carry-out a POWER ON.
- upgrade the firmware release.
- contact the Hotline.
213001 <location>Error in license checksum
Reaction: NONE
Acknowledge: NONE
Cause: When checking the checksum of the license key, an error was detected.
Remedy: Compare the license key (p9920) entered with the license key on the certificate of license.
Re-enter the license key and activate (p9920, p9921).
230001 <location>Power module: Overcurrent
Reaction: OFF2
Acknowledge: IMMEDIATELY
2-716
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005