Siemens SINUMERIK 840D sl Series Diagnostics Manual page 271

08/2005
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Configure link in accordance
with the MD or correct NC part program (channel MD: COUPLE_AXIS_n).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16779
Channel %1 block %2 coupling: too many couplings for axis %3, see active leading
axis %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions: More leading axes and spindles were defined for the specified axis/spindle than are
allowed. The last parameter to be specified is a leading value object/leading axis to which
the specified axis/spindle is already linked.
Reactions: - NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16780
Channel %1 block %2 following spindle/axis missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The following spindle/axis has not been written in the part program.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16781
Channel %1 block %2 master spindle/axis missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The master spindle/axis has not been programmed in the part program.
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16782
Channel %1 block %2 following spindle/axis %3 not available
Parameters: %1 = Channel number
%2 = Block number, label
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-271