Siemens SINUMERIK 840D sl Series Diagnostics Manual page 123

08/2005
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: • Continue machining with CANCEL and Start.
• Modify part program.
• Set setting data $SC_STOP_CUTCOM_STOPRE to FALSE.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10781
Channel %1 block %2 illegal orientation of involute with tool radius compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Tool radius compensation is possible for involutes only if the compensation plane
matches the involute plane.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10782
Channel %1 block %2 illegal curve type with tool radius compensation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This alarm occurs, if an attempt is made to apply the tool radius compensation to a curve
type for which this function is not implemented. The only cause at present: Involute with
3D tool radius compensation.
Reactions: - Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Remedy: Modify part program.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
10783
Channel %1 block %2 tool radius compensation type requires orientation transfor-
mation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: This alarm occurs, if an attempt is made to activate a tool radius compensation which
must enable a tool orientation change and the _Orientation transformation_ option is not
available. This alarm can only occur if one of the following G code is active in the G code
group 22:
• CUT3DC
• CUT3DCC
• CUT3DCCD
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-123