Siemens SINUMERIK 840D sl Series Diagnostics Manual page 235

08/2005
15 SynSpi option
16 Repos option
17 Spline option
18 Involute option
19 Poly option
20 Compress option
23 Masl option
24 ExtLang or ExtLanguage option not activated
25 TechCycle option
26 Liftfast option
27 ProgAccel option
33 AllAsupSynact option
34 CmdAxSpind option
35 Mea2 option
36 ProgAnaOut option
37 OptAaTOff option
41 MachineMaintenance option
42 PathFeedSAInput option
45 ElecTransfer option
46 Cut3D option
47 CDA option
48 Reserved: generic coupling option
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: Modify part program, retrofit option.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14782
Channel %1 block %2 non-active function used (identification %3)
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Fine ID
Definitions: A non-active function is used in the block
Brief description of the identification
1 Transformation
2 H number of the tool
Reactions: - Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Remedy: • Modify part program.
• Activate function.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
14790
Channel %1 block %2 axis %3 programmed by PLC
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Overview of Alarms
2-235