Siemens SINUMERIK 840D sl Series Diagnostics Manual page 320

Overview of Alarms
18300
Channel %1 block %2 frame: fine shift not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Allocation of a fine shift to settable frames or the basic frame is not possible since MD
$MN_FRAME_FINE_TRANS is not equal to 1.
Reactions: - Interpreter stop
- Interface signals are set.
- Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify program or set MD
$MN_FRAME_FINE_TRANS to 1.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
18310
Channel %1 block %2 frame: illegal rotation
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Rotations are not possible with NCU global frames.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18311
Channel %1 block %2 frame: illegal instruction
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: An attempt was made to read or write a frame which does not exist.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Modify part program.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
18312
Channel %1 block %2 frame: fine shift not configured
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Fine shift must be configurd with G58 and G59.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Modify machine data.
2-320
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
© Siemens AG, 2005. All rights reserved
08/2005