Operation; Overview - Renesas F-ZTAT H8 Series Hardware Manual

Section 8 DMA Controller
8.4

Operation

8.4.1

Overview

Table 8.5 summarizes the DMAC modes.
Table 8.5 DMAC Modes
Transfer Mode
Short address I/O mode
mode
Idle mode
Repeat mode
Full address Normal mode
mode
Block transfer
mode
A summary of operations in these modes follows.
I/O Mode: One byte or word is transferred per request. A designated number of these transfers are
executed. A CPU interrupt can be requested at completion of the designated number of transfers.
One 24-bit address and one 8-bit address are specified. The transfer direction is determined
automatically from the activation source.
Idle Mode: One byte or word is transferred per request. A designated number of these transfers
are executed. A CPU interrupt can be requested at completion of the designated number of
transfers. One 24-bit address and one 8-bit address are specified. The addresses are held fixed. The
transfer direction is determined automatically from the activation source.
Repeat Mode: One byte or word is transferred per request. A designated number of these transfers
are executed. When the designated number of transfers are completed, the initial address and
counter value are restored and operation continues. No CPU interrupt is requested. One 24-bit
address and one 8-bit address are specified. The transfer direction is determined automatically
from the activation source.
Rev. 3.00 Mar 21, 2006 page 206 of 814
REJ09B0302-0300
Activation
Compare match/input
capture A interrupt from
ITU channels 0 to 3
Transmit-data-empty and
receive-data-full interrupts
from SCI channel 0
External request
Auto-request
External request
Compare match/input
capture A interrupt from ITU
channels 0 to 3
External request
Notes
•
Up to four channels can
operate independently
•
Only the B channels
support external requests
•
A and B channels are
paired; up to two channels
are available
•
Burst mode or cycle-steal
mode can be selected for
auto-requests