Renesas F-ZTAT H8 Series Hardware Manual page 781

SSR—Serial Status Register
Bit
TDRE
Initial value
Read/Write R/(W)
Parity error
0 [Clearing conditions]
• Reset or transition to standby mode.
• Read PER when PER = 1, then write 0
in PER.
1 [Setting condition]
Parity error: (parity of receive data does
not match parity setting O/E bit in SMR)
Framing error (for SCI0)
0 [Clearing conditions]
• Reset or transition to standby mode.
• Read FER when FER = 1, then write 0 in FER.
1 [Setting condition]
Framing error (stop bit is 0)
Receive data register full
0 [Clearing conditions]
• Reset or transition to standby mode.
• Read RDRF when RDRF = 1, then write 0 in
RDRF.
• The DMAC reads data from RDR.
1 [Setting condition]
Serial data is received normally and transferred
from RSR to RDR
Transmit data register empty
0 [Clearing conditions]
• Read TDRE when TDRE = 1, then write 0 in TDRE.
• The DMAC writes data in TDR.
1 [Setting conditions]
• Reset or transition to standby mode.
• TE is 0 in SCR
• Data is transferred from TDR to TSR, enabling new
data to be written in TDR.
Note: Only 0 can be written, to clear the flag.
*
7 6 5
RDRF ORER
1 0 0
R/(W) R/(W)
* *
Multiprocessor bit
0 Multiprocessor bit value in
receive data is 0
1 Multiprocessor bit value in
receive data is 1
Appendix B Internal I/O Register
4 3
FER/ERS PER
0 0
R/(W) R/(W)
* * *
Transmit end
0 [Clearing conditions]
• Read TDRE when TDRE = 1, then write 0 in TDRE.
• The DMAC writes data in TDR.
1 [Setting conditions]
• Reset or transition to standby mode.
• TE is cleared to 0 in SCR and FER/ERS is
cleared to 0.
• TDRE is 1 when last bit of 1-byte serial character
is transmitted.
Error signal status (for smart card interface)
0 [Clearing conditions]
• Reset or transition to standby mode.
• Read ERS when ERS = 1, then write 0 in ERS.
1 [Setting condition]
A low error signal is received.
Overrun error
0 [Clearing conditions]
• Reset or transition to standby mode.
• Read ORER when ORER = 1, then write 0 in
ORER.
1 [Setting condition]
Overrun error (reception of next serial data
ends when RDRF = 1)
Rev. 3.00 Mar 21, 2006 page 753 of 814
H'B4
2 1
TEND MPB MPBT
1 0
R R R/W
Multiprocessor bit transfer
0 Multiprocessor bit value in
transmit data is 0
1 Multiprocessor bit value in
transmit data is 1
REJ09B0302-0300
SCI0
0
0