Renesas F-ZTAT H8 Series Hardware Manual page 477

SSR is initialized to H'84 by a reset and in standby mode.
Bit 7—Transmit Data Register Empty (TDRE): Indicates that the SCI has loaded transmit data
from TDR into TSR and the next serial transmit data can be written in TDR.
Bit 7: TDRE Description
0 TDR contains valid transmit data
[Clearing conditions]
•
•
1 TDR does not contain valid transmit data
[Setting conditions]
•
•
•
Bit 6—Receive Data Register Full (RDRF): Indicates that RDR contains new receive data.
Bit 6: RDRF Description
0 RDR does not contain new receive data
[Clearing conditions]
•
•
•
1 RDR contains new receive data
[Setting condition]
When serial data is received normally and transferred from RSR to RDR.
Note: The RDR contents and RDRF flag are not affected by detection of receive errors or by
clearing of the RE bit to 0 in SCR. They retain their previous values. If the RDRF flag is still
set to 1 when reception of the next data ends, an overrun error occurs and receive data is
lost.
Software reads TDRE while it is set to 1, then writes 0.
The DMAC writes data in TDR.
The chip is reset or enters standby mode.
The TE bit in SCR is cleared to 0.
TDR contents are loaded into TSR, so new data can be written in TDR.
The chip is reset or enters standby mode.
Software reads RDRF while it is set to 1, then writes 0.
The DMAC reads data from RDR.
Section 13 Serial Communication Interface
Rev. 3.00 Mar 21, 2006 page 449 of 814
(Initial value)
(Initial value)
REJ09B0302-0300