Commands In The Global Configuration Mode; Auto-Save - Siemens SIMATIC NET Configuration Manual

3.4.3

Commands in the global configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
Privileged EXEC mode again.
3.4.3.1

auto-save

Description
The CLI can save changes to the configuration automatically.
If you first want to test changes made to the configuration so that you can discard them
afterwards if necessary, you can disable the auto save function.
You are then in the Trial mode.
Changes to the configuration that you have not saved, are indicated by an asterisk in front of
the command prompt:
You save the changes to the configuration with the
With the
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
auto-save
As default the function is "enabled".
Result
The auto save function is enabled.
Further notes
You save changes to the configuration in the Trial mode with the
command.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
*cli(...)#
command, you enable the auto save function.
auto-save
configure terminal
or
end exit
.
write startup-config
3.4 Configuration Save & Restore
command to change to this mode.
command and are then in the
command.
write startup-config
Configuration
85