Show Wlan Vap (Access Point) - Siemens SIMATIC NET Configuration Manual

6.1.1.17

show wlan vap (access point)

Description
This command shows the configuration of the VAP interface.
Note
This command is available only in access point mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan vap <vapX 0/Y>
The parameter has the following meaning:
Parameter
vapX 0/Y
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The following settings of the VAP are displayed:
● Admin status
● SSID
● Broadcast SSID
● WDS only
● WDS ID
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
or
cli#
Description Range of values / note
VAP interface Enter a valid interface.
Network structures
6.1 WLAN
147