Wlan Client Mac Address (Client) - Siemens SIMATIC NET Configuration Manual

6.1.5.24

wlan client mac address (client)

Description
With this command, you specify the MAC address of the client.
Note
This command is only available in the client mode.
Requirement
● The MAC address is assigned to the client manually.
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan client mac address <mac address>
The parameter has the following meaning:
Parameters
mac address
Result
The MAC address was assigned to the client.
Further notes
You display the setting with the
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
MAC address of the client
show wlan client <wlan 0/X>
Range of values / note
aa:aa:aa:aa:aa:aa
command.
Network structures
6.1 WLAN
177