Wlan Any Ssid (Client) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.5.17

wlan any ssid (Client)

Description
With this command, you enable the "Any SSID" function. This setting is activated as default.
In client mode, the SCALANCE W700 attempts to connect to the access point with the best
transmission quality and that has suitable security settings. The clients can only connect to
the access point on which the "Broadcast SSID" option is enabled.
Note
This command is only available in the client mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameter assignment:
wlan any ssid
Result
The function is enabled.
Further notes
You display the setting with the
You disable the function with the
See also
no wlan any ssid (client) (Page 171)
vap broadcast ssid (access point) (Page 209)
170
show wlan client <wlan 0/X>
command.
no wlan any ssid
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
command.