Show Wlan Ssid-Table (Client) - Siemens SIMATIC NET Configuration Manual

Network structures
6.1 WLAN
6.1.1.16

show wlan ssid-table (client)

Description
This command shows a table with the SSIDs of the access points to which the client device
can establish a wireless link.
Note
This command is only available in the client mode.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call up the command with the following parameters:
show wlan ssid-table <wlan 0/X>
The parameter has the following meaning:
Parameter
wlan 0/X
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 25)".
Result
The table with the SSIDs configured on the client and their status is displayed.
146
or
cli#
Description
WLAN interface
Range of values / note
Enter a valid interface.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05