Functions specific to SCALANCE
4.5 Spectrum analyzer
This section describes the commands relevant for working with the spectrum analyzer.
Which the spectrum analyzer you can recognize and represent the electromagnetic signals
of a frequency range. You can measure the strength of all signals located in the environment
of the access point.
The "show" commands
This section describes commands with which general system properties can be displayed
show wlan spectrumanalyzer (Access Point)
This command shows the settings of the spectrum analyzer.
This command is available only in access point mode.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
Call the command without parameter assignment:
show wlan spectrumanalyzer
The settings of the spectrum analyzer are displayed.
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05