Commands In The Interface Configuration Mode; Alias - Siemens SIMATIC NET Configuration Manual

The parameter has the following meaning:
Parameter
string
Result
The name is created in the system.
3.1.10

Commands in the Interface configuration mode

This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
Global configuration mode.
● If you exit the Interface configuration mode with the
Privileged EXEC mode.
3.1.10.1

alias

Description
With this command, you assign a name to an interface. The name only provides information
and has no effect on the configuration.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
alias <interface-name>
The parameter has the following meaning:
Parameter
interface-name
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Description
Input box for the name
interface
Description
Name of the interface
Range of values / note
max. 255 characters
command to change to this mode.
command, you return to the
exit
command, you return to the
end
Range of values / note
max. 63 characters
Configuration
3.1 System
59