Wlan Interface Configuration Mode; Wlan Spectrumanalyzer Centerfrequency (Access Point) - Siemens SIMATIC NET Configuration Manual

4.5.2

WLAN Interface configuration mode

This section describes commands that you can call up in the WLAN Interface Configuration
mode. Depending on the Interface selected, various command sets are available.
In the Global Configuration mode, enter the
mode.
● If you exit the WLAN Interface Configuration mode with the
the Global Configuration mode.
● If you exit the WLAN Interface Configuration mode with the
the Privileged EXEC mode.
4.5.2.1

wlan spectrumanalyzer centerfrequency (Access Point)

Description
With this command you select the center frequency for measuring with the spectrum
analyzer.
Note
This command is available only in access point mode.
Requirement
● The WLAN interface is enabled.
● You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan spectrumanalyzer centerfrequency { show-frequencies | frequency}
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05
Functions specific to SCALANCE
command to change to this
interface wlan 0/X
exit
command, you return to
end
4.5 Spectrum analyzer
command, you return to
109