3.2 Load and Save
With this command, you load a file from a TFTP server into the file system of the device. The
TFTP protocol is used for the transfer. You can also display a list of available files.
● The name of the file is specified
● You are in the LOADSAVE configuration mode.
The command prompt is:
Call up the command with the following parameters:
The parameters have the following meaning:
The file types are displayed or the file is downloaded to the device.
You configure the name of the file with the
With the "
Shows the available files
Keyword for a file type to be loaded
Name of the file type
" command, you can display the file types.
show loadsave files
Range of values / note
max. 100 characters
SCALANCE W760/W720 to IEEE 802.11n Command Line Interface
Configuration Manual, 10/2015, C79000-G8976-C351-05